Applied Microphone Technology AMT WS Studio Double Clarinet/Oboe Microphone with AP40 Preamp
true
true
- Write a Review
The AMT WS Studio version combines the AMT WS Clip-On Double Microphone system with the AMT AP40 floor pre-amp. The AP40 converts the microphones to...Click To Read More About This Product
-
{
"pageUrl":"MusiciansFriendApp://ProductDetailsPage",
"pageParams":"ID=site8prod271154&isStyle=true"
}
- SKU
- 271154000000000 271154000000000
Earn up to 3,635 reward points.
The AMT WS Studio version combines the AMT WS Clip-On Double Microphone system with the AMT AP40 floor pre-amp. The AP40 converts the microphones to low impedance, it regulates the voltage to each microphone, and with certain models creates a specific frequency curve. The curve is necessary on certain models or musical instruments in order to maintain the most natural reproduction of sound in conjunction with achieving the most amount of gain before feedback in a live application. The output of the preamp is an XLR Low Impedance balanced output. The output sends signal at Mic Level.
The AMT WS is a low profile double condenser microphone system that attaches to the clarinet, alto and bass flute, or oboe with a ultra-miniature low mass clamp. It is specifically designed for the timbre of the clarinet. The microphone provides pure tonal reproduction while being unobtrusive. It has an even reproduction of sound across the entire instrument. The AMT WS features a flexible gooseneck, allowing the player to position the microphone for the best possible tone reproduction. It's rugged construction of anodized aviation aluminum makes it highly durable, while being lightweight and non-corrosive.
The AMT WS Studio comes with two isolation rings. Both instrument microphones are suspended in AMT's iso-ring technology which allows more gain before feedback and less handling noise. The AMT WS Studio version is meant to be used either in a Studio setting where close miking of an musical instrument is desired or in a professional level setting where the sound engineer needs control of the microphone.
Requires phantom power.
- 2 AMT WS condenser Microphones
- Flexible Gooseneck
- AMT AP40 Floor Pre-amp
- Hard shell protective case
- Element: Condenser
- Polar Pattern: Figure 8
- Frequency: 30Hz - 20kHz
- Sensitivity: -68dB+ 4dB
- Impedance: 150 Ohms
- Phantom Power:12 to 52 vDC or Self-powered battery
- Max input SPL: 140 dB
- Dimension: 13" Flex Arm
- Cable: 10'
- Weight (mic only): 31 grams
