Electro-Harmonix Logo

Electro-Harmonix Classics Flanger Hoax Guitar Effects Pedal   

  • Write a Review

BackgroundThe Flanger Hoax is made up of two separate phaser sections and their associate Delay Lines. The phaser sections are the Fixed Phaser and S...Click To Read More About This Product

In Stock & Ready To Ship

Gold Coverage: (What’s This?)

  • Shipping (48 Contigous U.S. States)
  • Your Price :
  Add to Cart
Add to Wish List

Earn up to 1,080 reward points.

Recommended Accessories

One of the most powerful modulation units ever designed!


The Flanger Hoax is made up of two separate phaser sections and their associate Delay Lines. The phaser sections are the Fixed Phaser and Swept Phaser. The Fixed Phaser is more like a traditional phaser, modulated by a low frequency sine wave call the Modulator. Each phaser circuit is followed by its own analog delay line, each of which can also be independently swept by the Modulator. Each phaser section can be bypassed to access the delay lines without any phase shift. To top it all off, there is a Feedback control that allows you to send the wet output of the pedal or the output of the Swept Phaser back into the phaser circuits.

  • Ethereal flange and phase effects, great for guitar, bass, and keyboards
  • True bypass
  • 5 delay modes including DC
  • 5 modulation modes from 270 degrees to DC
  • Fixed phaser with invert and bypass
  • Feedback from wet to swept and bypass
  • Direct, blended, and effect outputs
  • Blend control
  • 18DC-500 18v power supply included

With the Flanger Hoax, your creativity is your only limitation. Call or click to buy now!


Classics Flanger Hoax Guitar Effects Pedal

  • BLEND Knob: Mixes between the effect and the dry signal. The counter-clockwise position is all-dry, while the clockwise position is all effect. The result of the BLEND Control goes out the BLENDED OUTPUT jack
    DELAY MODE Switch: Selects between different phase shift combinations for the modulating waveform that sweeps the Fixed Phaser Delay line and the Swept Phaser Delay.
    FEEDBACK Knob: Sets the amount of signal that is fed back into both phase shift circuits. The counter-clocker-clockwise position gives you no feedback; the clockwise position yields maximum feedback.
    OFF Toggler Switch Position: All Feedback is turned off, no matter where the FEEDBACK knob is set.
    RATE Knob: Sets the frequency of the sine wave Modulator. The available frequency range is from 0.07 Hz (14 Seconds) to 220 Hz.
    SWPTToggler Switch Position: In the SWPT Position, the output of the Swept Phaser is fed back into Phaser circuits.
    Type: Flanger
    WET Toggler Switch Position: In the WET position, the wet signal (which is at the EFFECT OUTPUT Jack) is fed back to the phaser circuits.

© Woodwind & Brasswind. All rights reserved.     Terms & Conditions | Privacy Policy

You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.