| | |
| BLEND Knob | Mixes between the effect and the dry signal. The counter-clockwise position is all-dry, while the clockwise position is all effect. The result of the BLEND Control goes out the BLENDED OUTPUT jack |
| DELAY MODE Switch | Selects between different phase shift combinations for the modulating waveform that sweeps the Fixed Phaser Delay line and the Swept Phaser Delay. |
| FEEDBACK Knob | Sets the amount of signal that is fed back into both phase shift circuits. The counter-clocker-clockwise position gives you no feedback; the clockwise position yields maximum feedback. |
| OFF Toggler Switch Position | All Feedback is turned off, no matter where the FEEDBACK knob is set. |
| RATE Knob | Sets the frequency of the sine wave Modulator. The available frequency range is from 0.07 Hz (14 Seconds) to 220 Hz. |
| SWPTToggler Switch Position | In the SWPT Position, the output of the Swept Phaser is fed back into Phaser circuits. |
| Type | Flanger |
| WET Toggler Switch Position | In the WET position, the wet signal (which is at the EFFECT OUTPUT Jack) is fed back to the phaser circuits. |