HUSH The Pedal
Simply plug the HUSH in AFTER distortion boxes, wah-wahs, noisy vintage effects, or other noisy units and turn the Threshold knob until the noise goes away. It's that easy! You will not find a more effective noise reduction. Unlike noise "gates" that chop off the end of your notes, or ruin your sustain, HUSH the Pedal is actually a form of single-ended noise reduction that tracks your signal all the way and pushes the noise floor below the point where your ear can hear the noise. It does not hurt your sustain or chop off the end of your notes. Simply use the Threshold knob to smooth out your signal while wiping out noise. This is the best friend a guitar player could have!
Now hold on, partner. You must pay attention to the proper setup, with the HUSH pedal going AFTER your noisy stomp boxes. The HUSH is not designed to take the input directly from your guitar WITHOUT some processing happening between the guitar and the HUSH noise reduction. When setup correctly, with your signal going from your preamp and effects, or from your distortion and effects, into the HUSH, you WILL be amazed at how it will clean up the excess noise, including pickup buzz! The HUSH can also be used in your amplifier's effects loop. However, if you are running multiple effects through this loop, the HUSH should always be the last dynamic device in the signal chain, but before digital delays or reverbs.