The AMT WSW - Shure is a special version of the AMT WS. The microphone element remains with the same high level of quality that the WS achieves however is specially adapted to work with any Shure belt pack transmitter/wireless system such as the ULXS14 or ULXP14. The WS comes wired directly with a 4 pin connector to connect directly to any Shure wireless belt pack.
RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is<br />used). Refer to the frequency supplement supplied with the system.<br />Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)<br />Audio Frequency Response: 25 to 15,000 Hz, (± 2 dB<br />NOTE: Overall system frequency response depends on the microphone element.<br /><br />ULX1 Transmitter Input<br />Connector: TA4F<br />Input Configuration: Unbalanced, active<br />Actual Impedance: 18 kohms with lavalier microphone; 1 Mohms with instrument cable<br />Maximum Input Level: 10 Vpâp (12 dBV) for 1% THD at minimum gain setting<br />using 1 kHz signal.<br />TA4F Connector Pin Assignments: Pin 1: Tied to Ground; Pin 2: Tied to +5 V; Pin 3: Tied to Audio; Pin 4: Tied thru 20kohms Resistor to Ground. (On instrument adapter cable, Pin 4 floats)<br />Volt