The Heil Sound PR 35 is an incredibly versatile vocal mic. It has an amazing amount of rear rejection but exhibits no off-axis coloration, so it is l...Click To Read More About This Product
A cardioid that thinks it's an omni.
The Heil Sound PR 35 is an incredibly versatile vocal mic. It has an amazing amount of rear rejection but exhibits no off-axis coloration, so it is like having a supercardioid and omni mic in one! It works well for commercial broadcast, recording, and live sound reinforcement applications. When you need a smooth, flat response over a wide frequency range the Heil PR 35 is your mic. The PR 35 was designed around the acclaimed PR 30 element and incorporates a sorbothane shock mount to give you the best possible results.
The PR 35 mic achieves its exceptional performance by using a special magnet structure and a large aluminum 1-1/2" low-mass voice coil assembly. A carefully wound and placed hum bucking coil allows the Heil PR 35 to be placed near video monitors without unwanted hum or buzz. Special attention has been paid to the phasing plug assembly with equally placed ports that sense audio from behind the source. It then enters them out of phase, thus producing a very linear cardioid pattern. This reduces the proximity effect while achieving the extreme articulation across its smooth 40 Hz - 18 kHz frequency response. The Heil element can be used in extreme high sound pressure levels and is immune to overload conditions. It produces a beautifully smooth audio response without the inconvenience of phantom or outside DC powering.
The PR 35 microphone is equipped with a low-cut roll-off switch to prevent low-end feedback loops from ever getting started.
The Heil PR 35 mic's cardioid pattern offers the greatest rejection of unwanted audio at 180 off axis, which is directly behind the microphone; there is virtually no off-axis coloration.
Supplied with a microphone clip that mounts to any 5/8" 27-thread mic stand. It also comes with a leatherette carrying case and wind screen.
For amateur radio, a CC-1 XLR cable is required to interface with a transceiver.
7-2/3" long x 2" wide at mic vocal end and 1" wide at XLR-input end Largest dynamic element in a hand held microphone
Wide frequency response
Articulate natural mid range
2-position roll-off switch
Review Snapshotby PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about Heil Sound PR 35 Dynamic Microphone:
I checked this against several mikes including sennheiser 835, Shure beta 58,
Telefunken M80, Shure 58 and 57 and this is the one I use. My voice is rounder and any proximity effect makes the articulation unintelligible. The Heil has less proximity effect than the other mikes. It still has some though. This is the mike I use now even though I have to add a fair amount of high end to it to cut through the mix. When I do that, everyone says my voice sound natural like it does when I sing in a non amplified setting.
Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.