Old Blood Noise Endeavors Excess V2 Modulated Distortion Effects Pedal
true
true
- Write a Review
The Old Blood Noise Excess V2 modulated distortion effects pedal continues their journey to revive and expand sought-out pedal sounds of the ’80s. It...Click To Read More About This Product
-
{
"pageUrl":"MusiciansFriendApp://ProductDetailsPage",
"pageParams":"ID=site8prodL93026&isStyle=true"
}
- SKU
- L93026000001000 L93026000001000
Earn up to 1,095 reward points.
More sounds and more control for ultimate distortion and modulation potential.
The Old Blood Noise Excess V2 modulated distortion effects pedal continues their journey to revive and expand sought-out pedal sounds of the ’80s. It features three modes of modulation—Delay, Chorus and Fifth—each with Time, Depth and Volume controls. The Distortion section includes Gain, Tone and Volume controls, allowing you to access light overdrive through fuzzy distortion. Experiment running Distortion into Modulation, Modulation into Distortion or the two in separate parallel paths. The Excess V2 also includes soft touch switching and true relay bypass for each section, an expression jack to externally control Rate and Depth, and an internal trimpot to set wet-dry mix of the Modulation section.
- Three modes of modulation (Delay, Chorus, and Fifth) each with Time, Depth, and Volume controls
- Distortion section with control over Gain, Tone, and Volume
- Order switching to run Distortion into Modulation, Modulation into Distortion, or separate parallel paths
- Soft touch switching and true relay bypass for each section
- Expression jack to externally control Rate and Depth
- Internal trimpot to set wet-dry mix of Modulation section
Customize your sound with the Excess V2 effects pedal. Order today.
- Requires at least 125mA 9VDC center negative power
- Note: Expression Ramper is initially configured for TRS active at Tip for compatibility with Old Blood devices, but can be configured for TRS active at Tip, TRS active at Ring and TS using the internal jumpers. By default, it ships with a 50K digital potentiometer. This potentiometer is socketed and can be replaced with 10K and 100K values if needed (part code MCP41010-I/P and part code MCP41100-I/P respectively)
